Digital Surface Roughness Tester SRT6200

Ľutujeme, táto stránka je dostupná len v Angličtina (Britská). For the sake of viewer convenience, the content is shown below in the alternative language. You may click the link to switch the active language.

Features

This instrument is compatible with four standards of ISO, DIN, ANSI and JIS and is widely used in production site to measure surface roughness of various machinery-processed parts, calculate corresponding parameters according to selected measuring conditions and clearly display all measurement parameters. When measuring the roughness of a surface, the sensor is placed on the surface and then uniformly slides along the surface by driving the mechanism inside the tester. The sensor gets the surface roughness by the sharp built-in probe. This roughness causes displacement of the probe which results in change of inductive amount of induction coils so as to generate analogue signal, which is in proportion to the surface roughness at output end of phase-sensitive rectifier. The exclusive DSP processes and calculates and then outputs the measurement results on LCD.

  • Very easy to operate
  • Multiple parameter measurement: Ra, Rz
  • Highly sophisticated inductance sensor
  • Built-in lithium ion rechargeable battery and control circuit with high capacity
  • Small in size, light in weight and easy to use
  • Can communicate with PC computer for statistics, printing and analysing by the optional cable and the software for RS232C interface.
  • Manual or automatic shut down. The tester can be switched off by pressing the Power key at any time. On the other hand, the tester will power itself off about 5 minutes after the last key operation.

Specification

Display: 4 digits, 10 mm LCD, with blue backlight
Parameters:  Ra,  Rz
Display  Range Ra: 0.05-10.00um/1.000-400.0uinch   
Rz: 0.020-100.0um/0.780-4000uinch
Accuracy: Not more than 10%
Fluctuation of display value: Not more than 6%
Sensor : Test Principle: Inductance type
Radius of Probe Pin: 10um
Material of Probe Pin: Diamond
Measurement Force of Probe: 16mN(1.6gf)
Probe Angle: 90°
Vertical Radius of Guiding Head: 48mm
Maximum driving stroke: 17.5mm/0.7inch
Cutoff length (l): 0.25mm / 0.8mm / 2.5mm  optional
Evaluation length: 1~5 cut off  optional
Driving speed: sampling length = 0.25mm   Vt=0.135mm/s
sampling length = 0.8mm    Vt=0.5mm/s
sampling length = 2.5mm    Vt=1mm/s
returning                 Vt=1mm/s
Resolution : 0.001µm    if reading <10µm
0.01µm    if 10µm≤reading<100µm
0.1µm    if reading ≥100µm                              
Power Li-ion battery:  rechargeable
working conditions:  Temp. 0-50&deg;C     Humidity <80%
over Size:             140x57x48 mm        
Weight:    about 420 g